|
 AMSOIL
PowerSports Air Filters
AMSOIL
PowerSports Air Filters for dirtbikes and ATVs extend
equipment life, increase power and save money. PowerSports
Air Filters feature two layers of oil-wetted polyurethane
foam that provide a superior job at stopping dirt
while maximizing air flow. Their special design improves
performance, allows for better fuel economy and reduces
wear.
AMSOIL PowerSports Air Filters
save money. They are washable and reusable for hours
of trouble-free service. In addition, PowerSports
Air Filters have greater life expectancy than competitive
air filters.
PRODUCT DESCRIPTION
AMSOIL PowerSports 2-Stage Air Filters provide superior
performance in all three critical areas of filtration:
Efficiency (dirt-stopping), Capacity
(dirt-holding) and Resistance (air flow).
AMSOIL PowerSports 2-Stage Air Filters
are uniquely designed to hold wear-causing dirt while
allowing only clean air for better performance, better
fuel economy, lower exhaust emissions and longer engine
life. Also, AMSOIL PowerSports 2-Stage Air Filters
are washable and reusable for numerous hours of trouble-free
service.
AMSOIL PowerSports 2-Stage Air Filters
are especially designed for PowerSports such as ATV’s
and Dirt Bikes. The filters feature two distinct layers
of oil-wetted polyurethane foam, which provides a
network of interlocking cells that trap particles
primarily on the surface, yet allow a constant flow
of clean intake air for outstanding engine protection
and performance.
AMSOIL PowerSports 2-Stage Air Filters
are constructed of polyurethane foam and the 2-stage
foam’s thickness allows for even more filtering area
and capacity to trap dirt over a longer period of
time.
POWERSPORTS FILTER
CLEANING AND OILING PROCEDURES
The AMSOIL PowerSports 2 Stage Air Filter is constructed
with the highest quality foam filter media available.
This filter, when used in combination with AMSOIL
Foam Filter Oil (AFO), will maximize engine performance
and provide the most effective filtration available
for your engine.
NOTE: OIL
BEFORE USE! AMSOIL PowerSports 2 Stage Air Filters
are packaged dry. Proper filter oiling before use
is necessary to prevent dirt from entering the air
intake system. AMSOIL recommends using AMSOIL Foam
Filter Oil (AFO). AFO is properly designed with high quality
tacking agents that stick to dirt. AMSOIL Foam Filter
Oil (AFO) is available
in 8 oz. containers and can be purchased through your
AMSOIL Dealer.
Follow the instructions below to
properly prepare your filter for use.
Your local conditions and intended use
will determine how often your air filter should be
inspected and cleaned. Frequent cleaning and oiling
is necessary for best performance and protection against
engine wear.
Filter cleaning:
1) Carefully remove the air filter
being cautious not to knock any dust or dirt into
the carburetor opening. Clean any dirt from the
opening with a clean shop towel.
2) Clean filter in a solution of warm
water and mild detergent. Do not use strong solvents,
gasoline, or other fuels to clean the filter.
3) After washing, thoroughly rinse
the filter with clean water and allow it to air
dry. Note: Do not use high-pressure shop air
or heat to dry the filter. After the filter is completely
dry it can be re-oiled for further use.
Applying filter oil:
For best performance, use a generous
amount of filter oil and work it into foam media.
Squeeze out excess oil, leaving a uniformly oiled
filter.
A properly oiled filter will feel
oily or tacky to the touch on both the outer and
inner surfaces, but should not be dripping filter
oil.
When reinstalling the filter use a thin
film of Multi-Purpose Grease on the foam base to insure
a leak free seal between the filter and the housing.
|
